Performance - Internal Storage Mode

The performance of an internal storage device is dependent on the performance characteristics of the device as well as the file system being used. In order to isolate the effects of the latter, we first benchmarked the raw drives using HD Tune Pro 5.70. It was then formatted in NTFS and subject to our standard direct-attached benchmark suite.

Raw Drive Performance

HD Tune Pro allows us to run a variety of tests to determine transfer rates and IOPS for various artificial workloads. In addition, it also allows us to visualize how the performance varies as the tracking head moves from the outer parts of the platter towards the center (i.e, transfer rates as a function of the block address).

Empty drives are bound to perform very well, but, depending on the location of the data in the drive, we find that access rates can go as low as 112 MBps for sequential workloads. Write access times are a bit unpredictable due to the multi-segmented cache.

Random accesses are never the strong points of hard drives, and we see that the BarraCuda Pro delivers around 70 IOPS for 4K random reads and writes.

The extra tests help in putting some numbers to sequential accesses targeting different areas of the drive. It also provides some interesting numbers relevant to various random access workloads.

DAS Benchmarks

Consumers opting for drives such as the 12TB Seagate BarraCuda Pro typically need high-capacity local storage for holding and editing / processing large-sized multimedia files. Prior to taking a look at the real-life benchmarks, we first check what CrystalDiskMark has to report for the drive.

In order to tackle the real-life use-case of transferring large amounts of data back and forth from the drive, we created three test folders with the following characteristics:

  • Photos: 15.6 GB collection of 4320 photos (RAW as well as JPEGs) in 61 sub-folders
  • Videos: 16.1 GB collection of 244 videos (MP4 as well as MOVs) in 6 sub-folders
  • BR: 10.7 GB Blu-ray folder structure of the IDT Benchmark Blu-ray (the same that we use in our robocopy tests for NAS systems)
Seagate BarraCuda Pro 12TB robocopy Benchmarks (MBps)
  Write Bandwidth Read Bandwidth
Photos 219.23 205.51
Videos 231.42 219.46
Blu-ray Folder 234.05 230.02

These numbers are consistently around 15 - 20 MBps more than what we obtained for the 10TB drives last year.

While processing our DAS suite, we also recorded the instantaneous transfer rates and temperature of the drive. Compared to typical disk drives, the write transfers show higher instantaneous speeds due to a combination of the firmware and the 256 MB cache inside the drive. However, sustained write rates are comparable to other high-capacity drives when the cache is exhausted. The temperature of the unit at the end of the transfers (more than 250GB of traffic) rose by less than 5C, pointing to the power-efficiency of the platform.

For the use-case involving editing of multimedia files directly off the disk, we take advantage of PCMark 8's storage benchmark. The storage workload is a good example of a user workload, involving games as well as multimedia editing applications. The command line version allows us to cherry-pick storage traces to run on a target drive. We chose the following traces.

  • Adobe Photoshop (Light)
  • Adobe Photoshop (Heavy)
  • Adobe After Effects
  • Adobe Illustrator

Usually, PCMark 8 reports time to complete the trace, but the detailed log report has the read and write bandwidth figures which we present in our performance graphs. Note that the bandwidth number reported in the results don't involve idle time compression. Results might appear low, but that is part of the workload characteristic.

Seagate BarraCuda Pro 12TB PCMark8 Storage Benchmarks (MBps)
  Write Bandwidth Read Bandwidth
Adobe Photoshop (Light) 250.22 9.06
Adobe Photoshop (Heavy) 246.88 11.48
Adobe After Effects 89.74 8.85
Adobe Illustrator 196.38 8.42

Compared to the results from the 10TB drive last year, we find that the read workloads are slightly worse off, but, the write workloads are much faster.

Introduction Performance - Direct Attached Storage Mode
Comments Locked


View All Comments

  • Glock24 - Wednesday, November 15, 2017 - link

    Who wants to lose 12TB of data? Yeah, not me.
  • kingpotnoodle - Wednesday, November 15, 2017 - link

    That is why RAID was invented and backup should be routine.

    Only a fool stores their important data without disk redundancy and/or backup, whether they have 12KB or 12TB of it. Doesn't matter how much important data you have, if you don't want to lose it then don't entrust it to a single drive.
  • tipoo - Wednesday, November 15, 2017 - link

    Storage getting cheaper = backup getting cheaper. This has been true always.
  • imaheadcase - Wednesday, November 15, 2017 - link

    You be surprised how much data you DON'T need.
  • PeachNCream - Wednesday, November 15, 2017 - link

    Yeah from someone thats had a hard drive with pretty much my entire life saved on it (and without a current backup *sniff*) I can say there's a lot of data you can live without. Well all of it, but it is a pain to lose things.
  • MobiusPizza - Wednesday, November 15, 2017 - link

    Yeah, that's why I have 4 RAID 5 drives plus cloud backup for my terabytes of porn, I meant important data
  • GreenReaper - Sunday, September 2, 2018 - link

    Funny - I run a porn site on 4 2TB RAID-5 drives. And another four in a mostly-live backup. And another 4TB one off-site. (Plus all the caches.)

    Thankfully most of it is pictures, not video, or they'd need to be 12 12TB drives - or maybe a cluster.
  • GreenReaper - Sunday, September 2, 2018 - link

    Also: disks really do die. We've had four or five go over eight years - thankfully, none at once. You'd better be sure you have a backup - even at +200MBps you're talking 16 hours to rebuild 12TB, assuming *no* other I/O, and let's be honest: if you didn't have I/O you probably wouldn't need RAID. Realistically, it's likely to take a day; with heavy I/O, maybe a week. Consider using only up to about the first 2/3 and migrating to a 24TB drive array (once they exist).
  • fzzzt - Wednesday, November 15, 2017 - link

    This is why backups are used. RAID is not a replacement for a backup.
  • Lord of the Bored - Wednesday, November 15, 2017 - link

    A fool and his data are soon parted, as it were.

Log in

Don't have an account? Sign up now